Silex technology Embedded Intelligent Module SX-560 Especificaciones descargar pdf (Pagina 83)

Table 34 Network Commands

Command

Description

SH NW REALM

Shows the realm associated with the authentication ID, if applicable.

The default value is null (blank) string.

The deprecated command SH NW TTRE also returns this data.

Sample output:

Somewhere

SET NW

WPAGROUP

Enable or disable WPA group key mode.

If enabled, group keys can be used for data link encryption.

The default value is disabled.

Sample output:

SET NW WPAGROUP [ENABLE | DISABLE]

SH NW

WPAAUTO

Shows state of WPA auto connect flag

Sample output:

WPA-AUTO Enabled

SH NW

WPAGROUP

Shows state of the allow WPA group keys flag

Sample output:

WPA-GROUP Disabled.

SET NW

WPAPSK

Sets WPA PSK pass phrase or hex key.

This value is only used if the authentication mode is WPA-PSK or WPA2-PSK. The

argument to this command is either a pass phrase of 8 to 63 characters or exactly

64 hex characters representing the 256 bit PSK value.

Format:

SET NW WPAPSK <key>

SET NW RESET*

This command stops, and then resets the wireless network interface. This will

effectively disassociate the unit from an access point if it is connected. If the unit is

in wireless infrastructure mode, the unit will then scan and attempt to reconnect to a

suitable access point, if one is available.

Format:

SET NW RESET

*Not implemented in early releases of SX-560 firmware.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 103 104

Sin comentarios

Silex technology Embedded Intelligent Module SX-560 Especificaciones Pagina 83