Silex technology Embedded Intelligent Module SX-560 Especificaciones descargar pdf (Pagina 15)

Table 2 Status Monitors

Function

State

Status

Power

Orange (D8)

The module is receiving power

Off

The module is not receiving power

Blinking

Firmware update is in progress (Important: Do not

power off the module during the update process)

Network Status

Yellow (D9)

Yellow On

Wireless connection established

OEM Interface

The OEM interface is a 40-pin header (JP2) that is used to connect the SX-560 module to the SX-560-6900

Evaluation Daughtercard. It will also serve as the primary means of communications between the SX-560 and

your OEM device (refer to Chapter 5 for information on using this header to connect with your device).

Table 3 shows the OEM interface pinout for the Evaluation Daughtercard. Table 4 shows the OEM

interface signal descriptions. Please note that the OEM interface signals are not directly accessible from

the OEM header when the Evaluation Daughtercard is used. Rather, these signals are available through

convenient connectors on the Evaluation Daughtercard, such as the 26-pin I/O Header and the 9-pin

serial connectors. These connectors are described later in this chapter.

All input and output signals, except the differential signals, are 0 to 3.3 V logic signals.

Table 3 OEM Interface Pinout

SIGNAL

RESET-

GPIO_0

GPIO_1

GPIO_2

GROUND

+3.3VDC

GPIO_3

GPIO_4

GPIO_5

GPIO_6

GPIO_7

GPIO_8

GPIO_9

TXD0

GPIO_10

CTS0-

GROUND

+3.3VDC

USB+

RTS0-

USB-

RXD0

+3.3VDC

GROUND

SPI_CS-

TXD1

SPI_CLK

CTS1-

GROUND

+3.3VDC

SPI_MOSI

RTS1-

SPI_MISO

RXD1

+3.3VDC

GROUND

IIC_SDC

TXD2

IIC_SDA

RXD2

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 103 104

Comentarios a estos manuales

Sin comentarios

Silex technology Embedded Intelligent Module SX-560 Especificaciones Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Silex technology Embedded Intelligent Module SX-560