
48
ECable destination local IP port
number (required for E-Cable UDP
mode only)
Cable connection time resolution
Restoring Factory Default Settings
The factory default settings can be restored at any time. If you are using the SX-560 Evaluation
Daughtercard, hold down the test button for more than five seconds. If you are not using the evaluation
board, short GPIO7 on the OEM header to ground (4.7 K-ohm pull-up resistor connected to +3.3VDC) for
more than five seconds.
Modifying TCP/IP Settings
You can modify the TCP/IP settings using ExtendView, the web browser interface or the SX-560 module’s
internal configuration console.
To modify TCP/IP settings:
1. Using ExtendView, click the TCP/IP tab. The TCP/IP window displays.
Figure 14 TCP/IP Window
Comentarios a estos manuales