Silex-technology Embedded Intelligent Module SX-560 Manual de usuario descargar pdf (Pagina 25)

Configuring the SX-560

Silex

Page 19

Part Number 140-00192-100

Chapter 3

Configuring the SX-560

This chapter describes the methods for configuring the basic settings of the SX-560, including the IP

address, serial port settings, and wireless security. The SX-560 also has an extensive range of advanced

configuration capabilities that are described in Chapter 6, Appendix A, and Appendix B. The SX-560

configuration should be done by a network administrator or another person with technical knowledge of

TCP/IP networking and serial communications.

Basic Configuration Requirements

In order to use the SX-560, the following basic parameters must be configured:

TCP/IP Settings:

• IP Address

• Subnet Mask

• Router Address

Note: The TCP/IP settings can be automatically configured using DHCP.

Wireless Configuration Settings:

• SSID

• Mode (Infrastructure or Ad Hoc)

• Channel (required only if using Ad Hoc mode)

Security Settings:

• Wireless Encryption Mode (WPA2, WPA, WPA2-WPA, WEP)

• Wireless Encryption Settings

• Wireless Authentication Mode (WPA-PSK, Open System, Shared Key, TTLS, TLS, LEAP, PEAP,

EAP-FAST)

• Authentication Settings

Note: There are numerous possible encryption and authentication settings, and every network can

have different settings. Please refer to Appendix A for a detailed summary of these settings.

IMPORTANT: This chapter assumes that you are either using the SX-560-6900 Evaluation Daughtercard or that you have

made the appropriate connections to the SX-560 module OEM Header. Refer to Chapter 2 and Chapter 5 for information

on connecting to the SX-560 hardware.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 109 110

Sin comentarios

Silex-technology Embedded Intelligent Module SX-560 Manual de usuario Pagina 25